TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 206 of 772

TM 9-2350-260-20-1-2

ENGINE OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 2 of 6)

3.

Put drip pan on flat surface under oil cooler

connectors (C).

4.

Using 1-1/2 inch wrench, remove hose (D) from oil

cooler connector (C).

5.

Using 1-1/2 inch wrench, remove hose (E) from oil

cooler connector (C).

6.

Using plastic material (Item 41, Appendix D) and

masking tape (Item 57, Appendix D), wrap ends of

hoses (D) and (E) and oil cooler connectors (C) to

keep them clean and from dripping.

7.

Using 1/2 inch wrench, remove oil cooler vent

hose (F) at top of cooler.

8.

Using 1/2 inch wrench, remove four screws and

lockwashers (G).

Throw lockwashers away.

Go on to Sheet 3

TA147580

6-129