TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 197 of 772

TM 9-2350-260-20-1-2

ENGINE OIL COOLER REPLACEMENT (2A ENGINE) (Sheet 1 of 8)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

6-121

Installation

6-125

TOOLS:

1/2 in. socket with 1/2 in. drive

9/16 in. combination box and open end wrench

1-1/2 in. combination box and open end wrench

9/16 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

Slip joint pliers

Putty knife

Diagonal cutting pliers

1-3/4 in. open end wrench

SPECIAL TOOLS:

Ground hop kit (Item 30, Chapter 3, Section I)

SUPPLIES: Lockwire (Item 60, Appendix D)

Engine oil cooler connector gaskets (8682679) (2 required)

Thermostatic bypass valve gasket (7403580

Drip pan

Roll of masking tape, 1/2 in. wide (Item 57, Appendix D)

Plastic barrier material (Item 41, Appendix D)

Self-locking nut (MS21045-5) (6 required)

REFERENCES:

TM 9-2350-260-10

LO 9-2350-260-12

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-1)

Go on to Sheet 2

6-120