TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 204 of 772

TM 9-2350-260-20-1-2

ENGINE OIL COOLER REPLACEMENT (2A ENGINE) (Sheet 8 of 8)

15.

Position two new gaskets (S) on engine oil cooler

(C).

16.

Remove tape and plastic and position engine oil

cooler connectors (T) and (U) on oil cooler (C).

17.

Using 1/2 inch socket, install six new self-locking

nub (V) securing two engine oil connectors (T) and

(U) to engine oil cooler (C).

18.

Remove masking tape and plastic from hoses (W)

and (X).

19.

Using 1-1/2 inch wrench, install hose nut (W) to

connector (U).

20.

Using 1-1/2 inch wrench, install hose nut (X) to

connector (T).

22.

Replenish lubricating oil lot during engine oil cools

replacement (LO 9-2350-260-12).

Start and run

engine.

23.

Ground hop engine (page 5-54).

Check for oil

leaks at oil cooler and hose connections.

Tighten

any connections that are leaking.

24.

Stop engine and disconnect ground hop kit (page 67).

25.

Install powerplant (page 5-14).

End of Task

TA147578

6-127