TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 205 of 772

TM 9-2350-260-20-1-2

ENGINE OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 1 of 6)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

6-128

Installation

6-131

TOOLS:

1/2 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

5 in. extension with 1/2 in. drive

1/2 in. combination box and open end wrench

3/4 in. combination box and open end wrench

1-1/2 in. open end wrench

SPECIAL TOOLS:

Ground hop kit (Item 30, Chapter 3, Section I)

SUPPLIES:

Washer (MS9320-12)

Drip pan

Masking tape (Item 57,

Appendix D)

Plastic barrier material

(Item 41, Appendix D)

Lockwasher (MS35335-34) (4 required)

REFERENCES:

TM 9-2350-260-10

LO 9-2350-260-12

PRELIMINARY PROCEDURES:

Remove powerplant (page 5-27)

Remove engine shroud (page 9-2)

REMOVAL:

1.

Using 1/2 inch socket, remove screw (A) and

washer.

Throw washer away.

2.

Using 3/4 inch wrench, loosen valve (B) six

complete turns.

Go on to Sheet 2

TA147579

6-128