TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 53 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 18 of 26)
16.
Using 1-1/2 inch socket, install two flat washers
(D), two new lockwashers (E) and two capscrews
(F).
17.
Using torque wrench and 1-1/2 inch socket,
tighten two capscrews (F) 360-380 lb-Ft (48515
N.
•
m).
18.
Have one person hold universal joint gears In
alinement with final drive adapter while another
person, using pinch bar, pries final drive adapter
away from final drive into universal joint (each
side).
19.
Fit quick-disconnect ring (G) around final drive
adapter.
NOTE
When installing screw (H) hold onto
quick-disconnect ring (J) or it will snap
open and fall into engine compartment.
20.
Instal screw (H).
Using 3/4 inch socket, tighten
screw on both sides of tank.
21.
String new lockwire (J) (Item 60, Appendix D)
through screw (H) and opening quick-disconnect
ring (G) on both sides of tank.
Go on to Sheet 19
TA147944
5-43
Back to Top
