TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 55 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 20 of 26)
26.
Position angle bracket (L) to rear side wall (by
powerplant guide).
Hang tab of bracket onto tab
on compartment side wall.
27.
Install three screws (M), new lockwashers (N), and
washers (P) to secure angle bracket (L) to side
wall (both sides).
28.
Using 9/16 inch socket, tighten three screws (M)
(both sides) to secure bracket ) to side wall.
NOTE
Before connecting brake rod ends,
make sure two clamps (Q) are on each
boot (R).
NOTE
If your tank has a spring loaded sleeve type disconnect (S), perform step 29.
If it
has screw, lockwasher, and nut type, go to step 30.
29.
Push sleeve (S) forward, engage rod ends (use pliers if necessary), and push sleeve to rear to retain rod ends
(each side of tank).
Go on to step 31.
Go on to Sheet 21
TA147946
5-45
Back to Top
