TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 546 of 772

TM 9-2350-260-20-1-2
FUEL PUMP-TO-FUEL-WATER SEPARATOR HOSE ASSEMBLY REPLACEMENT (Sheet 5 of 5)
3.
Set FUEL PUMPS switch to ON.
4.
Set MASTER CONTROL switch to ON.
5.
Watch fuel-water separator bleed cap (A) until air release (bubbles) appears, then set MASTER CONTROL switch
to OFF.
NOTE
It may be necessary to perform steps
5 and 6 several times until a constant
fuel flow (no bubbles) from the bleed
cap (A) is observed.
Two persons
are required to perform steps 3, 4,
and 5.
6.
Wait about one minute and repeat step 4 until a constant free flow is observed at bleed cap (A).
7.
Using 7/16 inch wrench, turn bleed cap (A) clockwise until snug.
8.
Check for leaks.
Tighten or replace components as necessary.
9.
(2D engine only).
Perform operational check of automatic drain (age 7-245).
10.
Set MASTER CONTROL switch to OFF.
11.
Disconnect engine from powerplant ground hop (page 5-67).
12.
Install 2A powerplant (page 5-14) or 2D powerplant (page 5-40).
End of Task
TA148352
7-277


Back to Top