TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 547 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR CONTROL ASSEMBLY TO FUEL-WATER SEPARATOR DRAIN SOLENOID WIRING

HARNESS REPLACEMENT (2D ENGINE) (Sheet 1 of 1)

TOOLS:

5/16 in. combination box and open end wrench

Slip-joint pliers

PRELIMINARY PROCEDURE:

Remove powerplant (page 5-27)

REMOVAL:

1.

Using wrench, remove screw and washer (A) from

clamp (B).

Remove clamp from harness (C).

2.

Using pliers, disconnect harness (C) from control

assembly (D) and drain solenoid (E), and remove

harness from powerplant.

INSTALLATION:

1.

Connect harness (C) to control assembly (D) and drain solenoid (E) a shown.

2.

Using pliers, tighten connectors on ends of harness (C).

3.

Position clamp (B) around harness (C) a shown, being sure to place clamp around leads at control assembly.

4.

Using wrench, install screw and washer (A) through clamp (B) into control assembly mount.

5.

Install powerplant (page 540).

End of Task

TA148353

7-278