TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 582 of 772

TM 9-2350-260-20-1-2

FUEL PRIMER INLET LINE TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 5)

11.

Using 11/16 inch wrench to hold nipple (S) and 5/8

inch wrench on nut T), remove nut (T).

NOTE

It may be necessary to slightly bend

tube assembly (U) before it can be

removed.

12.

Remove tube assembly (U).

CLEANING AND INSPECTION:

1.

Clean tube assemblies and nut with rags (Item 65,

Appendix D).

2.

Inspect all parts for damage or wear.

Replace any

damaged or worn part.

INSTALLATION:

NOTE

It may be necessary to slightly bend

tube assembly (A) before it can be

placed in position.

1.

Place tube assembly (A) in position.

2.

Start nut (B) on nipple (C) and leave finger tight.

3.

Using two 5/8 inch wrenches, install nipple (D) in

nut (E).

4.

Position tube assembly (A) and clamp (F).

5.

Using 7/16 inch wrench, install screw and

lockwasher (G).

6.

Using 5/8 inch wrench, tighten nut (B).

Go on to Sheet 4

TA148388

7-313