TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 588 of 772

TM 9-2350-260-20-1-2

PRIMER PUMP INLET TEE REPLACEMENT (Sheet 1 of 1)

TOOLS:

5/8 in. combination box and open end wrench

8 in. adjustable wrench (crescent)

9/16 in. combination box and open end wrench

SUPPLIES:

Rags (Item 65, Appendix D)

PRELIMINARY PROCEDURES:

Shut off fuel supply to primer pump (TM 9-2350-260-10)

REMOVAL:

CAUTION

Do not move tube assemblies which

may cause bending.

1.

Using crescent wrench to hold tee (A), use 5/8

inch wrench to disconnect fitting (B) from tee (A).

Move fitting (B) and tube assembly away from tee.

2.

Using 5/8 inch wrench, disconnect fitting (C) from

tee (B).

Move fitting (C) and tube assembly away

from tee.

3.

Using 9/16 inch wrench, remove line (D).

4.

Using 9/16 inch wrench, remove adapter (E).

5.

Using crescent wrench, loosen tee (A) from primer

pump (F) and remove.

INSTALLATION:

1.

Using crescent wrench, install tee (A) into primer pump (F).

2.

Using 9/16 inch wrench, install adapter (E) into primer pump (F).

3.

Using 9/16 inch wrench, install line (D) in primer pump (F).

4.

Using 5/8 inch wrench, install fitting (C) with tube assembly to tee (A).

5.

Using 5/8 inch wrench, install fitting (B) with tube assembly to tee (A).

End of Task

TA148394

7-319