TM 9-2350-260-20-1-2
MANIFOLD HEATER (LEFT AND RIGHT BANK) FUEL RETURN TUBE ASSEMBLY REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
7-343
Cleaning and Inspection
7-345
Installation
7-346
TOOLS:
5/16 in. combination box and open end wrench
8 in. adjustable wrench
Flat-tip screwdriver
Hammer
9/16 in. combination box and open end wrench (2 required)
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1/2 in. combination box and open end wrench
SUPPLIES:
Rags (Item 65, Appendix D)
Sealing compound (Item 27, Appendix D)
Dry cleaning solvent (Item 54, Appendix D)
Container
PERSONNEL:
Two
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-1)
Remove engine shroud (page 9-2)
CAUTION
When removing or installing fuel lines, care must be taken not to damage fittings
and threads or twist or distort fuel lines or hoses.
NOTE
There are two manifold heater fuel return tube assemblies, one for left bank and
one for right bank.
Removal and installation procedures for both tube assemblies
are similar.
This procedure covers right bank tube assembly.
Go on to Sheet 2
TA148417
7-342