TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 605 of 772

TM 9-2350-260-20-1-2
MANIFOLD HEATER RETURN FUEL CHECK VALVE REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
1.
Coat thread of elbow (A), nipple (B), check valve (C), and elbow (D) with sealing compound (Item 28, Appendix D).
NOTE
Some 2D engines require a filtering
disc between elbow (A) and solenoid
valve.
2.
Using 9/16 inch wrench, install elbow (A) to
solenoid valve in position shown.
3.
Install nipple (B) to elbow (A).
4.
Install check valve (C) to nipple (B).
5.
Install elbow (D) to check valve (C).
6.
Using proper wrenches, tighten and aline parts
(B), (C), (D) to be able to connect end fitting of
hose assembly (E) to elbow (D).
7.
Connect hose assembly (E) to elbow (D).
8.
Using 7/16 inch and 9/16 inch wrenches, tighten
hose assembly (E) connection to elbow (D).
9.
Connect for powerplant test run (page 5-54).
10.
Operate primer pump (TM 9-2350-260-10) and check for leaks.
If leaks are found, tighten connection as required.
11.
Disconnect powerplant test kit (page 5-67).
12.
Install engine shroud (page 9-3).
13.
Install 2A powerplant (page 5-14) or 2D powerplant (page 5-40).
End of Task
TA148411
7-336


Back to Top