TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 70 of 772
TM 9-2350-260-20-1-2
2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 9 of 16)
STALL TEST:
NOTE
This test is performed only to determine engine power loss or transmission
slippage.
NOTE
Before performing stall test, check brake adjustment (page 13-2)
1.
Adjust brakes (page 13-2).
2.
Remove brake lever assembly from each side of
transmission (page 13-91).
3.
Install long brake apply levers (A) supplied with
stall check it.
4.
Using 3/4 inch wrench, remove two nut and
lockwashers (B) from transmission.
5.
Using nuts and lockwashers removed in step 4,
install brake stall check tool (D) to transmission.
6.
Using 3/4 inch wrench, tighten two nut and
lockwashers (B).
CAUTION
Rotation of retainer (E) should be
limited to one-half turn.
7.
Using alien wrench, turn brake apply screw (C) in
clockwise direction until retainer (E) begins to turn.
Brakes will then be applied to preset loading.
Go on to Sheet 10
TA147960
U.S. GOVERNMENT PRINTING OFFICE:
1986 - 642-089
5-60
Change 1
Back to Top
