TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 76 of 772
TM 9-2350-260-20-1-2
2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 15 of 16)
WARNING
Fuel is delivered under high pressure from fuel pump to injector nozzles.
Injury to
personnel could result if contacted by spray from loose or defective fuel line.
CAUTION
DO NOT run engine for more than 10 minutes and do not exceed 700-750 rpm.
WARNING
Take all necessary safety precautions to eliminate possible injury to personnel or
damage to equipment.
Stand clear of both transmission output flanges whenever
the engine is running.
Hearing protection is required.
8.
Start engine and run engine at idle speed (700-750 rpm) (TM 9-2350-260-10).
9.
Wearing goggles, check for leakage at all fuel line connections.
10.
If leak is observed, shut down engine (TM 9-2350-260-10) and tighten or replace bad fuel line or fittings.
11.
When no leaks are observed, shut down engine (TM 9-2350-260-10).
12.
Using 1-1/4 inch socket remove cooling fan nut.
13.
Remove spacers from fan drive shafts.
14.
Install cooling fans (page 9-49).
15.
Install left bank engine access covers 2A engine (page 6-86) or 2D engine (page 6-91).
16.
Install right bank engine access covers 2A engine (page 6-78 or 2D engine (page 6-82).
17.
Install engine shroud (page 9-3).
Go on to Sheet 16
TA147966
5-66
Back to Top
