TM 9-2350-260-20-1-2
2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 13 of 16)
19.
After adjusting servobands, repeat steps 15 thru 18.
If slippage still exists, notify support maintenance
20.
When test are completed, shut down engine (TM 9-2350-260-10).
21.
Using allen wrench, turn brake apply screw (C) counterclockwise until brakes are fully released.
22.
Using 3/4 inch wrench, remove two nuts and lockwashers (B).
Remove brake stall check tool (D) from
transmission.
Throw lockwashers away.
23.
Using 3/4 inch socket, install two nuts and new lockwashers (B) to transmission.
24.
Using torque wrench and 3/4 inch socket tighten nuts (B) to 70-80 lb-ft (90-108 N
•
m).
25.
Remove brake apply lever (A) from brake apply shaft.
26.
Install brake lever assembly to both sides of transmission (page 13-93).
Go on to Sheet 14
TA147964
5-64