TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 742 of 772

TM 9-2350-260-20-1-2
TRANSMISSION SHROUDS REPLACEMENT (Sheet 2 of 8)
Right Intermediate Shroud Replacement
REMOVAL:
NOTE
When removing the right intermediate shroud on a 2A engine, remove engine
wiring harness according to page 10-338, steps 1 thru 7 and proceed to step 5 of
this procedure.
When removing the rigid intermediate shroud on a 2D engine, start
with step 1 of this procedure.
1.
Using spanner wrench, disconnect connector (A) from generator connector.
2.
Remove grommet (B) from shroud (C) and cable assembly (D).
3.
Inspect grommet (B) for defects.
If defective, replace grommet.
4.
Pull cable assembly (D) through shroud (C).
Go on to Sheet 3
TA146886
9-40


Back to Top