TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 751 of 772

TM 9-2350-260-20-1-2

ENGINE COOLING FAN REPLACEMENT (Sheet 3 of 4)

6.

Using slip joint pliers, remove 16 cotter pins (G)

and throw away.

7.

Using 1/2 inch socket and wrench, remove 16

nuts, bolts, and washes (H) holding fan (J) to hub

K).

8.

Place block of wood on hub (K).

Using hammer,

strike block

wood until hub (K) is separated from

fan (J).

9.

Inspect hub (K) for damages.

Replace hub if

damaged.

INSTALLATION:

1.

Position hub (A) on fan (B), machined surface up

(marked TOP).

2.

Using 1/2 inch socket and open end wrench,

install 16 bolts, nuts, and washers (C).

Using

torque wrench, torque nut to 1-20 lb-ft (227 N

•

m).

3.

Using slip joint pliers, install 16 new cotter pins

(D).

Go on to Sheet 4

TA146895

9-49