TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 389 of 783

TM 9-2350-260-20-1-3

ENGINE STARTER WIRING HARNESS REPLACEMENT (2A ENGINE)(Sheet 2 of 4)

NOTE

When removing cables, tag and identify to make sure they are installed in proper

position.

REMOVAL:

1.

Using pocketknife, remove protective covering at (A)

and (B).

2.

Using 3/4 inch wrench, remove nut and lockwasher

(B) securing ground straps (C), large cables (D) and

(E), and small cable (F) to terminal on front of starter

(G).

Remove cables from terminal.

Throw

lockwasher away.

3.

Using 3/4 inch wrench, remove nut, external tooth

lockwasher, and split lockwasher (A) securing two

large cables (H) and (J) and small cable (K) to

terminal on front of starter solenoid (L).

Remove

cables from terminal.

4.

Using 1/2 inch wrench, remove two screws and

lockwashers (M) from two clamps (N) and remove

clamps (N) from cables.

Throw lockwashers away.

5.

Using flat-tip screwdriver on eight screws (P) and 3/8

inch wrench on eight nuts (Q), remove screws (P)

and nut and lockwashers (Q) from bracket (R).

Remove two cable assemblies (S) and (T) from

bracket and engine.

Throw lockwashers away.

6.

Using 1/2 inch wrench on three screws (U), remove

screws and three lockwashers (U).

Remove bracket

(R) from engine.

Go on to Sheet 3

TA147409

10-377