TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 390 of 783

TM 9-2350-260-20-1-3

ENGINE STARTER WIRING HARNESS REPLACEMENT (2A ENGINE)(Sheet 3 of 4)

INSTALLATION:

1.

Position two cable assembles (A) and (B) onto

engine with male connector on top.

Install two

screws and new lockwashers (D) through clamps (C)

into engine.

2.

Install two clamps (C) onto two cable assemblies (A)

and (B) as shown.

3.

Position bracket (E) onto engine as shown and

install three screws and new lockwashers (F).

Make

sure upper screw (F) is installed through clamp (G).

4.

Using 1/2 inch wrench on three screws (F), tighten

screws.

5.

Install cable receptacles into bracket (E) as shown

and install eight screws (H), into bracket (E) and

receptacles.

Start eight nuts and new lockwashers

(J) onto screws (H).

6.

Using Phillips screwdriver on screws (H) and 3/8

inch wrench on nut (J), tighten screws and nuts.

Go on to Sheet 4

TA147410

10-378