TM-9-2350-261-20-2
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4
TM-9-2350-261-20-2 - Page 106 of 1008
TM 9-2350-261-20-2
REPLACE AUXILIARY POWER (SLAVE) RECEPTACLE (ALL EXCEPT
M577A2 AND M1068) — Continued
0218 00
INSTALLATION
NOTE
Steps 1 - 8 tell you how to install the late model slave receptacles. Steps 9 - 14 tell you how
to install the early model slave receptacles.
NOTE
Make sure protective cap retaining cord is attached to receptacle lower mount screw.
1.
Install insulator (1), new gasket (2), and auxiliary power receptacle (3) in master switch panel (4). Secure with four
screws (5), washers (6), and new locknuts (7).
2.
Install new grommet (8) on ground lead (9). Route lead out of master switch panel (4). Install grommet in panel.
3.
Place ground lead (9) on instrument panel strut hull mount. Secure with screw (10), washer (12), and nut (11).
4.
Install circuit 50 lead (13) and circuit 49 lead (14) on terminal of master switch (15). Secure with washer (16) and
nut (17).
5.
Install ground lead (9) on negative post (18) of auxiliary power receptacle (3). Secure with screw (19) and new
lockwasher (20).
6.
Install circuit 50 lead (13) on positive post (21) of auxiliary power receptacle (3). Secure with screw (22) and new
lockwasher (23).
7.
Install master switch panel (4) on distribution box. Secure with eight screws (24), washers (25), and new locknuts (26).
8.
Connect circuit 37 lead (27) to connector (28).
0218 00-4
Back to Top
