TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 544 of 1008

TM 9-2350-261-20-2

REPLACE TRANSMISSION HIGH OIL TEMPERATURE SWITCH — Continued

0320 00

INSTALLATION

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

1.

Coat threads of switch (2) with sealing compound.

2.

Install switch (2) in tee (3). TIGHTEN SWITCH TO 240–264 LB-IN (27–34 N·M) TORQUE. Use torque wrench.

3.

Connect circuit 327 lead (1) to switch (2).

FOLLOW-THROUGH STEPS

WARNING

Loose clothing is dangerous around moving belts and pulleys. You could get badly hurt if your

clothes get caught in moving parts.

1.

Start engine to check for oil leaks at transmission high oil temperature switch. Stop/shutdown engine (see your -10).

2.

Close power plant front access door and raise trim vane (see your -10).

END OF TASK

0320 00-2