TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 536 of 1008

TM 9-2350-261-20-2

REPLACE ENGINE LOW OIL PRESSURE SWITCH — Continued

0316 00

INSTALLATION

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

1.

If removed, coat threads of bushing (3) with sealing compound.

2.

Install bushing (3) in engine block (4).

3.

Install switch (2) in bushing (3).

4.

Connect circuit 34 lead (1) to switch (2).

FOLLOW-THROUGH STEPS

1.

Connect battery ground lead (WP 0294 00).

2.

Turn MASTER SWITCH to ON and observe low oil pressure warning light. Light should go on (see your -10).

3.

Start engine and check for oil leaks at engine low oil pressure switch. Low oil pressure warning light should go out after

engine is started. Stop engine (see your -10).

4.

Turn MASTER SWITCH to OFF (see your -10).

5.

Close power plant front access door, and raise trim vane (see your -10).

END OF TASK

0316 00-2