TM-9-2350-261-20-2
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4
TM-9-2350-261-20-2 - Page 757 of 1008
REPLACE TRACK TENSION ADJUSTER AND MOUNT — Continued
5.
Rotate mount (4). Install two screws (6).
NOTE
When using torque wrench with torque wrench adapter, torque value must be corrected.
Procedure for converting torque value is i n
WP 0120 00
.
6.
TIGHTEN SCREW (5) AND TWO SCREWS (6) TO 130-140 LB-FT (176-190 N·M) TORQUE. Use torque wrench
and adapter.
7.
Install washer (7) and screw (8) in shaft idler arm. TIGHTEN SCREW TO 130-140 LB-FT (176-190 N·M) TORQUE.
Use torque wrench.
8.
Install washer (9) and screw (10) on mount (4). TIGHTEN SCREW TO 130-140 LB-FT (176-190 N·M) TORQUE.
Use torque wrench.
FOLLOW-THROUGH STEPS
1.
Connect and adjust track (see your -10).
2.
Road test carrier to check that ad juster is i nstal led pr oper ly (
WP 0120 00
).
END OF TASK
0378 00-3/4 blank
0378 00
TM 9-2350-261-20-2
Back to Top
