TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 761 of 1008

REPLACE SHOCK ABSORBER — Continued

INSTALLATION

1.

Install new inner seal (1) on support arm pin (2).

NOTE

Exercise new shock absorber to the fully extended position and move shock absorber back and

forth several times until resistance can be felt throughout the entire length of the stroke.

Make sure shock absorber is installed with large end of bearings installed first.

2.

Install shock absorber (3), new outer seal (4), and shoulder washer (5) on support arm pin (2).

3.

Install new inner seal (1), shock absorber (3), new outer seal (4), and shoulder washer (5) on hull bracket (6).

4.

Secure shock absorber (3) with two nuts (9).

5.

TIGH TEN T W O NUTS (9) TO 60-80 L B-FT (

81

-1

09

N ·M) TORQU E. Use torqu e w rench . Secure w ith n ew cot

t

e

pins (10).

FOLLOW-THROUGH STEPS

1.

Inst all r oad wheel (

WP 0371 00

).

2.

Road test carrier to check that shock absorber i s installed properly (

WP 0120 00

).

END OF TASK

0379 00-3/4 blank

0379 00

TM 9-2350-261-20-2