TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 747 of 1008

TM 9-2350-261-20-2

REPLACE IDLER WHEEL ARM BEARINGS AND SEALS — Continued

0376 00

2.

If removed, install new bolt(s) (13) in hub (12).

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

3.

Apply light coat of sealing compound to threads of relief valve (14) and grease fitting (15). Install valve and fitting

in hub (12).

4.

Pack inner bearing (16) with grease. Install bearing in rear of hub (12).

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

5.

Apply light coat of sealing compound to outer surface of new seal (17).

037600-3