TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 740 of 1008

TM 9-2350-261-20-2

REPLACE ROAD WHEEL SUPPORT ARM, BEARINGS, AND SEALS — Continued

0374 00

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

5.

Put light coat of sealing compound on outer surface of new seal (3).

6.

Install new gasket (5), retainer (4), and seal (3) in rear of housing (6). Use replacer. Secure with three new washers (2)

and six screws (1). Do not tighten screws at this time.

7.

Fill support arm housing (6) with grease until grease appears around retainer (4).

8.

TIGHTEN SIX SCREWS (1) TO 168–228 LB-IN (19-26 N·M) TORQUE. Use torque wrench (WP 0780 00, Item

102). Bend tabs on new washers (2).

0374 00-4