TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 735 of 1008

TM 9-2350-261-20-2

REPLACE ROAD WHEEL HUB — Continued

0373 00

7.

Place hub (1) on road wheel support arm (2). Completely pack cavity in hub with grease.

8.

Pack outer bearing (3) with grease. Install in hub (1).

9.

Install washer (4) and nut (5) on support arm (2). Tighten nut to adjust bearing as follows:

a.

TIGHTEN NUT (5) TO 140-150 LB-FT (190-203 N·M) TORQUE. Use torque wrench.

b.

Back off nut (5) until there is no torque.

c.

TIGHTEN NUT (5) TO 70-75 LB-FT (95-102 N·M) TORQUE. Use torque wrench.

d.

Back off nut to align nearest cotter pin hole in nut with cotter pin hole in support arm (2).

10. Install new cotter pin (6) in support arm (2).

11. Install new gasket (7), hub cap (8), and four screws (9) in hub (1).

12. Fill hub (1) with grease (WP 0120 00).

FOLLOW-THROUGH STEPS

1.

Install road wheel (WP 0371 00) (T130) or (WP 0372 00) (T150).

2.

Road test carrier to check that hub is installed properly (WP 0120 00).

3.

Check track tension (see your -10).

END OF TASK

0373 00-5/6 blank