TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 781 of 1008

TM 9-2350-261-20-2

REPLACE TORSION BAR — Continued

0385 00

NOTE

Special socket head cap screw is used with adapter.

4.

Thread special screw through adapter.

NOTE

Screw is installed with head inside adapter.

5.

Thread adapter on puller, then thread adapter with screw into torsion bar.

CAUTION

When removing or installing torsion bars, theindexormissingtoothontheanchorendof

torsion bar must align with index on spline in road wheel arm, to allow bar to pass through.

6.

Pull torsion bar (3) from torsion bar anchor (4). Use slide hammer on puller.

7.

Remove puller and adapter from torsion bar.

8.

If torsion bar (3) is broken, remove as follows:

a.

Remove road wheel end of torsion bar in the same way as unbroken torsion bar.

b.

Pull or drive end of broken bar from its splined seat in torsion bar anchor (4).

038500-3