TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 783 of 1008

TM 9-2350-261-20-2

REPLACE TORSION BAR — Continued

0385 00

6.

Install screw (5) in plug (4).

NOTE

You may need to jack carrier, to raise road arm, before positioning road wheel lifter.

7.

Position road wheel lifter (WP 0371 00) (T130) or (WP 0372 00) (T150).

FOLLOW-THROUGH STEPS

1.

Install floor plates for third and fourth torsion bars (WP 0436 00).

2.

Install driver’s rear floor plate for second torsion bar, left side only (WP 0439 00).

3.

Install power plant rear access panel for second torsion bar, right side only (see your -10).

4.

Install driver’s front floor plate for first torsion bar, left side only (WP 0439 00).

5.

Install power plant for first torsion bar, right side only (WP 0131 00).

6.

If removed, install shock absorber (WP 0379 00).

7.

Install road wheel (WP 0371 00) (T130) or (WP 0372 00) (T150).

8 .

Road test carrier to check that torsion bar is installed properly (WP 0120 00).

9.

Stop/shutdown engine (see your -10).

END OF TASK

0385 00-5/6 blank