TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 786 of 1008

TM 9-2350-261-20-2

REPLACE TORSION BAR ANCHOR — Continued

0386 00

REMOVAL

1.

Remove two cotter pins (1) and pins (2) from torsion bar anchor (3). Discard cotter pins.

2.

Remove two screws (4) from anchor (3) on fifth torsion bar anchors (M1064 only).

3.

Remove anchor (3) and preformed packing (5) from hull mount. Discard preformed packing.

CLEAN, INSPECT, AND REPLACE

1.

Check torsion bar anchor and pins for wear and damage. Replace if needed.

INSTALLATION

NOTE

Preformed packing (1) is installed on third, fourth, and fifth anchor on all carriers.

1.

Place new preformed packing (1) and torsion bar anchor (2) on hull mount.

2.

Install two screws (3) in anchor (2) on fifth torsion bar anchor (M1064 only). TIGHTEN SCREWS TO 320-330 LB-FT

(434-447 N·M) TORQUE. Use torque wrench.

0386 00-2