TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 537 of 932

TM 9-2350-261-20-3

REPLACE RAMP LINKAGE (M1064 ONLY) — Continued

0560 00

CLEAN, INSPECT, AND REPAIR

1.

Check rods. Replace any rod that is bent, damaged or has stripped threads.

2.

Check bumpers. Replace bumpers that are cracked, torn, or not flexible.

3.

Check support blocks. Replace blocks that are worn or binding.

4.

Check cross-shaft arm. Remove grooves and scratches with fine sandpaper. Replace worn or pitted arm.

5.

Check catch and latch. Replace damaged catch or latch.

INSTALLATION

1.

Place catch (26) on ramp. Secure with new square washer (25) and screw (24). Bend corner on washer to secure screw.

2.

Place washers (23) and trip plate (22) on hull top plate. Make sure you install the same number of washers (23) in the

same positions from which they were removed. Secure with two washers (21) , new lockwashers (20), and screws (19).

Do not tighten screws at this time.

056000-3