TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 562 of 932

TM 9-2350-261-20-3

REPLACE WIRE ROPE AND PULLEYS (ALL EXCEPT M1064) — Continued

0564 00

INSTALLATION

1.

Route wire rope (6) through pulley mount.

2.

Align two pulleys (9) with pulley mount. Secure with two headed pins (8) and new cotter pins (7).

3.

Align wire rope end fitting with ramp mount bracket. Secure with headed pin (5) and new cotter pin (4).

4.

Align guard (3) and two washers (2) with upper pulley mount. Secure with new spring pin (1).

FOLLOW-THROUGH STEPS

1.

Connect wire rope to ramp cylinder (WP 0593 00).

2.

Install rear floor plate (WP 0436 00).

3.

Raise ramp (see your -10). Check that wire rope and pulleys work right.

4.

Stop engine (see your -10).

END OF TASK

0564 00-2