TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 564 of 932
TM 9-2350-261-20-3
REPLACE WIRE ROPE AND PULLEYS (M1064 ONLY) — Continued
0565 00
INSTALLATION
1.
Route wire rope (3) through pulley mount.
2.
Align three pulleys (6) with pulley mount. Secure with three headed pins (5) and new cotter pins (4).
3.
Align wire rope eye with ramp mount bracket. Secure with headed pin (2) and new cotter pin (1).
FOLLOW-THROUGH STEPS
1.
Connect wire rope to ramp cylinder (WP 0593 00).
2.
Install rear floor plate (WP 0437 00).
3.
Start engine (see your -10).
4.
Raise and lower ramp several times (see your -10). Check to see that wire rope and pulleys operate properly.
5.
Raise and lock ramp (see your -10).
6.
Stop engine (see your -10).
END OF TASK
0565 00-2
Back to Top
