TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 323 of 785

TM 9-2350-261-34

REPAIR DRIVER’S HATCH COVER HINGES — Continued

0041 00

ASSEMBLY

1.

Clamp or tack weld new hinge (1), (2), or (3) on hatch cover (4). Check alignment of cover hinges with hinges on hull.

2.

Insert spring shield (5) through hinges (3) or (2). Seat shield in hinge (1).

3.

Make sure hinges are aligned and spaced as shown.

4.

Weld hinge (1), (2), or (3) to hatch cover (4). See TC 9-237. Use electrode type 5356.

5.

Clean the weld area and apply touch-up paint to repaired area. See TM 43-0139.

FOLLOW-THROUGH STEPS

1.

Install driver’s hatch cover (see your -20).

2.

Reconnect battery ground (see your -20).

END OF TASK

0041 00-2