TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 329 of 785

TM 9-2350-261-34

REPLACE/REPAIR DRIVER’S LEVEL INDICATOR (M901A1 ONLY) — Continued

0043 00

NOTE

Make sure all leads are tagged before removing.

2.

Unsolder three electrical leads (4) from indicator switch (5) on indicator bracket (3).

3.

Remove two screws (6), lockwashers (7), and level indicator (8) from plate nuts (9) on indicator bracket (3). Discard

lockwashers.

4.

Remove nut (10), lockwasher (11), marker (12), and switch (5) from bracket (3). Discard lockwasher.

5.

Remove nut (13), lockwasher (14), terminal lug (15), ring spacer (16), lamp retainer (17), and lamp (18) from bracket

(3). Discard lockwasher.

6.

Drill out four rivets (19) and remove two plate nuts (9) from indicator bracket (3). Discard plate nuts and rivets.

INSTALLATION

NOTE

Make sure carrier is on level ground. When installing driver’s level indicator, make sure cable

is not pinched against housing.

1.

Install new plate nuts (9) with four new rivets (19) on indicator bracket (3).

2.

Install nut (13), new lockwasher (14), terminal lug (15), ring spacer (16), lamp retainer (17), and lamp (18) on indicator

bracket (3).

3.

Install nut (10), new lockwasher (11), marker (12), and indicator switch (5) on bracket (3).

4.

Install two screws (6), new lockwashers (7), and level indicator (8) in plate nuts (9) on indicator bracket (3).

0043 00-2