TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 326 of 785

TM 9-2350-261-34

REPAIR DRIVER’S HATCH COVER HULL HINGES — Continued

0042 00

ASSEMBLY

1.

Clamp or tack weld new hinge (1) or (2) on mounting ring (3). Set cover on mounting ring. Check alignment of cover

hinges with hinges of ring (3).

2.

Insert spring shield (4) through hinges (1) or (2) and cover hinges (5), (6), and (7). Seat shield in cover hinge (7).

3.

Make sure hinges (1) or (2) are aligned and spaced as shown.

4.

Weld hinge (1) or (2) to mounting ring (3) and hull. See TC 9-237. Use electrode type 5356.

5.

Clean the weld area and apply touch-up paint to repaired area. See TM 43-0139.

FOLLOW-THROUGH STEPS

1.

Install driver’s hatch cover (see your -20).

2.

Reconnect battery ground (see your -20).

END OF TASK

0042 00-3/4 blank