TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 491 of 785

TM 9-2350-261-34

INSTALL ENGINE COOLANT HEATER KIT (M1064 ONLY) — Continued

0061 00

3.

Clean external pipe threads of bushing (1), shutoff cock (2), elbow (3), and elbow (4) with solvent, cleaning compound.

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

4.

Apply a thin, even coat of primer and then sealing compound (WP 0105 00, Item 17) to cleaned external pipe threads of

bushing (1), shutoff cock (2), elbow (3), and elbow (4). Do not apply primer or sealing compound beyond small end

of threads.

5.

Install bushing (1), shutoff cock (2), and elbow (3) in coolant pump (5).

6.

Install two mounting saddles (6) on mounting bracket (7). Secure with four screws (8), washers (9), and nuts (10).

7.

Install two clamps (11) in two mounting saddles (6).

8.

Install coolant heater (12) to two mounting saddles (6). Secure with two clamps (11).

9.

Install elbow (4) in control valve (13).

0061 00-2