TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 589 of 785

TM 9-2350-261-34

INSTALL CARGO HATCH ARMOR SHIELDS (M113A2 ONLY) — Continued

0075 00

9.

If holes are already in carrier, remove and discard six 1/2 inch (13 mm) screws and washers, two 5/8 inch (16 mm)

screws and washers, and four 3/8 inch (10 mm) screws and washers.

10. If pintle socket plate mounting holes are not drilled and tapped in cargo cover and on inside rear hull plate, go to Step 11.

If these holes have been drilled and tapped, go to Step 13.

11. Measure center point for four holes as shown below. Two holes are on cargo cover. Two holes are on inside rear hull

plate.

0075 00-4