TM 9-2350-311-34-1
NOTE
Wiring harness maybe removed from hull with slave start receptacle attached or
leads can be pulled out of receptacle with sockets as required. If wiring harness
removed is without receptacle, skip steps 5 and 6.
5 Remove slave start receptacle (19) as follows:
(a) Remove four screws (20), four Iockwashers (21), and gasket (22) from battery compartment bulkhead.
Discard Iockwashers and gasket.
(b) Push slave start receptacle (19) with mounting plate (23) into driver’s compartment.
6 Remove four screws (24) and four Iockwashers (25) and separate slave start receptacle (19) from mounting
plate (23). Discard Iockwashers.
7-63