TM-9-2350-311-34-1
HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 1994
TM-9-2350-311-34-1 - Page 70 of 352
TM 9-2350-311-34-1
4-2 REMOVAL AND INSTALLATION OF ENGINE- AND TRANSMISSION-RELATED
COMPONENTS — CONTINUED
b. Installation — Continued
32 Install new Iockwasher (13) and screw (12) to attach transmission-to-oil cooler hose (11 ) to transmission
housing (14).
33 Install hose connector (10) and connect transmission-to-oil cooler hose (11 ). Provide 0.63- to 0.87-in. (16.0- to
22.1 -mm) clearance between exhaust manifold (84) and hose (11 ).
34 Tighten four screws (8) to oil cooler housing (9).
35 Tighten nut (6) and connect oil cooler-to-transmission hose (7).
36 Install two elbows (4) to two filters (5). Remove elbows from ends of engine oil filter-to-oil cooler hose (2) and
oil cooler-to-oil filter hose (3).
37 Tighten two hose connector nuts (1) and connect engine oil filter-to-oil-cooler hose (2) and oil cooler-to-oil filter
hose (3).
4-14
Back to Top
