TM-9-2350-311-34-1
HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 1994
TM-9-2350-311-34-1 - Page 72 of 352
CAUTION
TM 9-2350-311-34-1
4-3 SEPARATION OF ENGINE FROM TRANSMISSION AND TRANSFER ASSEMBLY —
CONTINUED
a. Separation — Continued
Use care to avoid damage to powerplant components during disassembly, cleaning,
inspection, repair, and assembly. Nicks, scratches, and dents, resulting from careless
handling, may cause oil leakage or improper functioning. This could result in
transmission failure. All defective parts must be replaced. To prevent damage to
equipment, handle heavy components with slings and hooks and block transmission
for support in required positions.
1 Attach sling to hoist. Attach sling to engine at four lifting eyes (1) and take up slack in sling lines.
Ensure that transmission support at transfer assembly will prevent transmission from
rolling when engine is disconnected.
2 Remove six screws (2), six flat washers (3), and six Iockwashers (4) from tie bar (5) at transmission (6).
Discard Iockwashers.
NOTE
Record length of screws upon removal.
ENGINE MODEL 7083-7391 SHOWN
4-16
Back to Top
