TM-9-2350-311-34-2

CAB, ARMAMENT, SIGHTING AND FIRE CONTROL, ELEVATING AND TRAVERSING SYSTEMS AND ASSOCIATED COMPONENTS HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

TM-9-2350-311-34-2 - Page 161 of 552

TM 9-2350-311-34-2

NOTE

Be sure single tab of key washer is alined in keyway of keyway washer on M182 mount.

5 Install two keyway washers (16), two new key washers (14), and two round nuts (15) onto variable recoil

cylinder rods (17). Bend tabs of two key washers over two round nuts to lock.

When working on mount and cannon assembly breech components with cannon assembly pushed

out of battery, block cannon assembly with fabricated breech stand under breech ring body to pre-

vent accidental elevation of cannon assembly and possible injury to personnel or damage to equip-

ment.

6

Install fabricated breech stand (2) into position under breech ring body (3) to hold mount in position.

7

Remove fabricated lifting arm (19) from breech ring body (3) and raise through gunner’s escape hatch.

5-17