TM-9-2520-215-34
CROSS-DRIVE TRANSMISSION ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 2005
TM-9-2520-215-34 - Page 171 of 508
TM 9--2520--215--34
BRAKE AIR VALVE ASSEMBLY AND RELATED LINKAGE REPAIR –
CONTINUED
0037 00
ASSEMBLY – Continued
4. Install and fasten linkage rod plunger stop (15) into sleeve (16).
15
16
NOTE
Make certain key enters slot in brake air valve.
5. Install new oil seal (11), retainer (12), and key (14) on brake air valve linkage shaft (4). Position brake air valve
assembly (10) in the brake air valve body (13). Install the linkage shaft with new oil seal (11), retainer (12), and
key (14) through the brake air valve body (13) and into the brake air valve assembly (10).
6. Install cap screw (8) and lockwasher (9) in the brake air valve assembly (10). Torque screw to 26 to 32 ft--lb (32.3
to 43.4 N
S
m).
7. Using a hammer and soft drift, seat retainer (12) and oil seal (11) in brake air valve body (13).
8. Install lubrication fitting (7) in brake air valve linkage bracket (6). Install key (5) on brake air valve linkage shaft (4)
and install brake air valve linkage lever (3) on shaft (4).
9. Install cap screw (1) and lockwasher (2) on brake air valve linkage lever (3). Torque screw to 26 to 32 ft--lb (32.3
to 43.4 N
S
m).
5
7
2
1
3
10
9
8
6
4
13
12
11
14
NOTE
FOLLOW--ON MAINTENANCE:
Install brake air valve assembly
(WP 0036 00)
END OF WORK PACKAGE
0037 00--5/6 blank
Back to Top
