TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 173 of 508

TM 9--2520--215--34

0038 00--1

STEER CLUTCH HOUSING ASSEMBLY REPLACEMENT

0038 00

THIS WORK PACKAGE COVERS:

Removal, Installation

INITIAL SETUP:

Tools and Special Tools

General mechanic’s tool kit (item 1, WP 0088 00)

Hoist (2000 lb lifting capacity min)

Torque wrench (item 26, WP 0088 00)

Materials/Parts

Lockwasher (18) (item 100, WP 0087 00)

Gasket (item 38, WP 0087 00) (right side)

Gasket (item 53, WP 0087 00) (left side)

Equipment Conditions

Steer control valve assembly removed

(WP 0026 00)

Inspection plate and gasket removed

(WP 0036 00)

NOTE

There are two steer clutch housing assemblies, left and right. Both steer clutch assemblies

are removed and installed in the same manner. These procedures show the right steer clutch

housing assembly only. Differences will be noted.

Note the quantity, size, and location of hardware during removal to aid in installation.

REMOVAL

1. Attach hoist and remove 19 mounting bolts (1) and 18 lockwashers (2) from right steer clutch housing (3). Install

two mounting bolts (1) as jacking screws into threaded holes (4). Loosen right steer clutch housing (3) from

transmission by tightening jacking screws (1). Discard lockwashers.

1

2

4

3

1