TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 178 of 508

TM 9--2520--215--34

0039 00--2

STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED

0039 00

DISASSEMBLY – Continued

3. Remove housing from carrier assembly and position the housing gears upward, on bench. Remove 32

self--locking bolts (6) and output planetary sun gear (7). Discard self--locking bolts.

6

7

4. Install compressor assembly and tighten the attaching bolts until steer tie shaft drive gear (8) moves downward

1/8 to 3/16 inch. Tap steer tie shaft gear ball bearing (9) downward with a soft hammer or mallet until the snap

ring (10) can be removed. Remove and discard snap ring.

9

10

8