TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 183 of 508

TM 9--2520--215--34

0039 00--7

STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED

0039 00

DISASSEMBLY – Continued

14. Using two 3/8–24 bolts as lifters, remove steer clutch piston (28) assembly from housing (4) hub.

NOTE

Do not remove lubrication valve unless replacement is necessary.

15. Remove lubrication valve (32) by drilling end of pin (33) where it is peened into clutch piston. Using an

11/32--inch drill, drill a 3/16--inch deep hole in exact center of the pin. Locate a suitable punch in center of hole

and drive out pin. Discard pin.

28

4

33

32

16. Turn over housing (4) and remove snap ring (34) securing ball bearing (35). Turn the housing over again and tap

out bearing (35). Discard snap ring.

4

35

34