TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 189 of 508

TM 9--2520--215--34

0039 00--13

STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED

0039 00

ASSEMBLY

1. Install sleeve (49), threaded end first, through new seal ring (50) and then into bore in housing (4). Install nut

(48), flat side first, into sleeve (49). Torque nut to 150 to 200 lb--ft (203.4 to 271.2 N

S

m). Stake thin outer lip of nut

into mill slot of sleeve.

2. Install elbow (46) into threaded end of sleeve (49). Install elbow (47) into nearest tapped hole in housing (4).

Tighten both elbows until tube assembly can be fitted properly into elbows. Elbows are positioned toward front of

housing at an elevation of approximately 24 degrees above horizontal.

50

47

49

4

48

46

3. Install tube assembly (43). Tighten nuts at ends of tube assembly.

43