TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 198 of 508

TM 9--2520--215--34

0039 00--22

STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED

0039 00

ASSEMBLY – Continued

30. Rotate steer clutch drive gear (17) until 12 holes in gear align with tapped holes in steer clutch piston under it.

Install 12 spacers (21) into holes in gear (17).

17

21

31. Install steer clutch pressure plate (16), grooved side up. Align plate (16) holes with gear holes. Install 12 new

self--locking screws (15). Torque screws to 19 to 23 lb--ft (25.8 to 31.2 N

S

m).

NOTE

Slots in screws heads must not align with grooves in pressure plate.

32. Stake each screw (15) head at two points into groove in steer clutch pressure plate (16).

16

15