TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 200 of 508

TM 9--2520--215--34

0039 00--24

STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED

0039 00

ASSEMBLY – Continued

36. Install steer tie shaft drive gear (8), flat side down, onto steer clutch hub and center it. Use two 7/16--20 bolts to

align gear holes with those in steer clutch hub.

37. Remove 7/16--20 bolts used as guides. Install tie shaft drive gear ball bearing (9), snap ring end up. Tap bearing

assembly down until seated against spacer.

9

8

NOTE

Snap ring has L--shape cross section. Flat side of ring must be installed up. When compressor

assembly is released, bearing is pushed up by Belleville springs and locks snap ring in groove.

38. Install compressor assembly. Compress steer tie shaft drive gear (8). Install new snap ring (10).

10

8