TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 239 of 508

TM 9--2520--215--34

0047 00--3

OUTPUT REDUCTION GEAR OUTPUT SHAFT AND RELATED PARTS REPAIR

– CONTINUED

0047 00

CLEANING

WARNING

WARNING

Thoroughly clean output shaft assembly (1), particularly the ten tapped holes (11) by washing in dry--cleaning solvent.

Blow dry with compressed air. See WP 0018 00 for additional cleaning procedures.

07i246ma

1

11

INSPECTION

See WP 0018 00 for general inspection and repair recommendations.

FIT AND WEAR LIMITS

Check the following parts to the dimensions listed. Replace if not within the specified dimensions.

PART NAME

CHECK POINTS

ACCEPTABLE LIMITS

Output shaft

Roller bearing

Shaft small bearing surface OD

Bearing fit on shaft

Shaft large bearing surface OD

Bearing OD

Bearing fit on shaft

Bearing ID

Fit of bearing on shaft

1.3771 to 1.3776 in.

Wear limit: 1.3769 in.

0.0001T to 0.0009L

5.1187 to 5.1194 in.

Wear limit: 5.1182 in.

9.0539 to 9.0551 in.

0.0000 to 0.0030L

5.1171 to 5.1181 in.

0.0006T to 0.0023T